HDL-240 Compact data logger
Price:
$4,675.00
HDL-240 is the evolution of Magneti Marelli’s successful data logger line offering increased logging performance (data throughput and number of channels) in a smaller, lighter package.
HDL-240 is designed to provide an all-round data logging capability and can operate both in stand-alone mode and as an expansion to the new racing dashboard family (FBO).
This versatile data acquisition unit is specifically developed for racing applications which require high resolution data from a large number of channels, either coming from internal measurements or via CAN or Ethernet lines. HDL-240 deploys a modern high-performance, low consumption 32-bit CPU, with a computational power of over 200 DMIPS and hardware floating-point support.
Two convenient bi-colour LEDs show logger status/ diagnostic information at a glance (powered, logging, etc.).
Benefits
• Data download via Ethernet link
• Upgrades HRDL and HFD loggers with no loom changes
• SW selectable NTC/PT1000 temperature sensor
• SW selectable VRS, Hall or Rate sensor
• Hardware accelerated floating point arithmetic
• Integrates seamlessly with Marelli dashboard displays
• Pick-up inputs for wheel speed and distance measurement
• Compact and robust design, easy to install
• 16 Single-ended @12bit / 2kHz sampling (*)
• 4 Differential @12bit / gain 100
• 2 Thermocouple @12bit
• 4 Temperature (PT1000/NTC)
• 2 Pick-ups, Hall effect or Rate sensor
• 4 Hall effect or Rate sensor
• 32 GByte internal disk for data recording
• Data recording on USB pendrive
• 1024 logged channels
• 200 kByte/s logging rate
• Sampling rates up to 2000 Hz
• 2x CAN 2.0B communication buses
• 4x Ethernet 100 Mbit/s lines
• Tri-axial 16g accelerometer
• 2x green/red LEDs on top for visible logger status feedback
• Fully supported by SYSMA setup tool and WinTAX4 data analysis tool
(*) option for higher rates, please contact us.
Inputs
Analogue Single-ended (12 bit) 16
Differential (12 bit, gain 100) 4
K-type thermocouple (12 bit) 2
NTC/PT1000 temperature sensor (SW selectable) 4
Internal temperature 1
VRS Pick-up, Hall or Rate sensor (SW selectable) 2
Hall effect or Rate sensor (SW selectable) 4
Lap trigger pull-up/pull-down (SW selectable) 2
“Code Load” enable pin 1
Outputs
Voltage references (5.0V 70 mA max) 4
Half-bridge/high-side/low-side outputs (5A max total continuous; full-bridge mode available) 4